Measured Maker

Cross Stitch Fabric Size Calculator

From your pattern's stitch count and your fabric count: the finished design size and the piece of fabric to cut, with margins, on any Aida or linen.

A 140 x 112 stitch design on common counts

Margin 3 in on every side; the cut size is rounded up to the next half inch. Skip to the calculator

FabricDesign sizeFabric to cut
11-count12 3/4 in x 10 1/8 in19 in x 16 1/2 in
14-count10 in x 8 in16 in x 14 in
16-count8 3/4 in x 7 in15 in x 13 in
18-count7 3/4 in x 6 1/4 in14 in x 12 1/2 in
22-count6 3/8 in x 5 1/8 in12 1/2 in x 11 1/2 in

Your own stitch count, margin or metric sizes: use the calculator.

Open the calculator

Units for sizes
Your pattern and fabric

The number on the label: 14 for 14-count Aida, 28 for 28-count linen. Counts are given to the inch even on metric labels.

Floss (optional)

Most charts list a stitch count for each colour in the key. Leave empty to skip.

Designs measured out

  • 140 x 112 stitches on 14-count Aida: Width 140 / 14 = 10 in and height 112 / 14 = 8 in. With the margin added on all four sides, cut 16 in x 14 in.
  • 28-count linen over two threads: Over two threads, a count of 28 gives 14 stitches per inch, the same as 14-count Aida, so the same design needs the same 16 in x 14 in piece.
  • The same design on 18-count: The design shrinks to 7 3/4 in x 6 1/4 in. With margins that is 13.78 x 12.22 in, so cut 14 in x 12 1/2 in.

Where the design sits on the fabric

Fabric for a 140 by 112 stitch design on 14-count AidaThe design area, 10 in by 8 in, sits in the middle of a 16 in by 14 in piece of fabric with a 3 inch margin on every side.design 10 in x 8 incut fabric 16 in x 14 in3 in
The first worked example: design area in blue, margin all round.

Pre-cut pieces and floss

DMC sells its 14-count Aida pre-cut at 15 x 18 in and 19.7 x 24 in. Leaving the usual margin, the smaller piece holds a design of up to 126 x 168 stitches and the larger one up to 191 x 252 stitches; the buy list says which one, if either, fits your chart.

For floss, add up the stitches of one colour from the chart key and type them in. On 14-count Aida with two strands a skein covers about 2191 full crosses; the chart below gives the other counts.

Linen, evenweave and over two

Aida is woven in blocks, one stitch per block, so its count is the stitches per inch. Linen and evenweave are counted in single threads, and most patterns stitch them over two threads, which halves the stitches per inch.

If your stitches look too big or too small on a test corner, check the count on the label before you change the pattern.

How far one skein of floss goes

A DMC skein is 8 m of thread made of 6 strands you separate. This chart turns that into full cross stitches per skein for each fabric count and the number of strands you stitch with, so you can count skeins from the stitch totals in a chart key.

Stitches per inchFabricOne strandTwo strandsThree strands
1111-count Aida3444 crosses1722 crosses1148 crosses
1414-count Aida, or 28-count over two4383 crosses2191 crosses1461 crosses
1616-count Aida, or 32-count over two5009 crosses2504 crosses1669 crosses
1818-count Aida, or 36-count over two5635 crosses2817 crosses1878 crosses

Each figure is the thread geometry of a full cross plus 25% for tails and travel. Backstitch, French knots and confetti stitches use more.

Skein length and strand count come from DMC's own product page for its six-strand floss; the crosses per skein are this page's thread geometry plus the stated allowance.

Fabric questions

How do I convert a design from 14-count to 18-count?

The stitch count stays the same; only the stitch size changes. Each side of the design gets 1.29 times smaller, so divide the stitch count by the new count again rather than scaling the old inches.

How much margin should I leave?

The calculator starts at 3 in on every side, which leaves room to frame or mount the piece. A small card or ornament can manage with about 2 in; a piece for a large frame may want more. Change the margin field to suit.

How many stitches fit across a finished size?

Multiply the size by the stitches per inch: 10 in across on 14-count Aida holds 140 stitches. For a chart, it is the other way round: divide its stitch count by the count.

How the sizes are found

Stitches per inch is the fabric count, or half of it when you stitch over two threads. The design size is the stitch count divided by that; the margin is added to both sides of each direction. The cut size is rounded up to the next half inch (or whole centimetre) so you never cut short; sizes are shown to the nearest eighth of an inch.

Defaults you can change, and why they are set this way:

  • 25% extra floss on top of the stitch geometry: Starting and ending tails and the travel between stitches vary with how you stitch; the geometry alone is a floor, so treat skein counts as a guide and buy a spare for large areas

Sources:

What to check yourself

  • Count backstitch, borders and the space between motifs in the width and height you type; the calculator only knows the numbers you give it.
  • Stretching in a hoop or frame can change the final size slightly.
  • Read the count off the fabric's label. On linen and evenweave it is threads to the inch; worked over two, you get half that many stitches.

Checked charts

The sizes and skein counts here are held to 8 cases: 6 written out step by step, separately from the calculator code, and 2 checked against a published fabric guide or DMC's sizes.

Chart and fabricMust come out asStep by step
140 x 112 stitches on 28-count worked over two threads, 3 in margin14 stitches per inch, cut 16 in x 14 inWorked over two threads, 28-count gives 28 / 2, which is 14 stitches per inch, the same as 14-count Aida (Cross Stitched's Aida guide), so the piece is the same 16 x 14 in.
140 x 112 stitches on 18-count, 3 in margin18 stitches per inch, cut 14 in x 12 1/2 in140 / 18 is 7.78 in; with 3 in on each side that is 13.78 in, which goes up to the next half inch, 14 in. 112 / 18 is 6.22 in, plus 6 in is 12.22 in, up to 12 1/2 in.
140 x 112 stitches on 14-count, 3 in margin; one colour of 4382 stitches in 2 strands2191 crosses per skein, 2 skeinsA skein is 8 m, 314.96 in, of six strands: three two-strand lengths, 944.88 in. One cross takes (2 x 1.4142 + 2) / 14, which is 0.3449 in, and 0.4311 in with the 25% allowance. 944.88 / 0.4311 gives 2191 crosses, so 4382 stitches is exactly two skeins.

More sewing and needlework tools

All sewing, quilting & needlework calculators